PRO 600W Stereo Power Amplifier 8 Ohm Studio Amp for Large Loud Speaker Systems

600W (2x 300W) Stereo Power Amplifier

Overview:

Stereo power amplifiers are most commonly found in setups around the home and in installs such as offices, bars, restaurants and shops when only one source device is needed to play on either 2 or 4 speakers. Power amplifiers are usually required when larger and more powerful speakers are needed for an install. Our compact, high quality and versatile power amplifiers are extremely simple to install and very easy to use on a daily basis.

Equipped with LED level meters, left and right channel volume control and attractive dials, they look great in all installations. We stock a full range of power amplifiers with different wattage settings. If this one is not quite right for you, please get in touch.

Features:

2 selectable line inputs
1x – Left and right XLR 3 inputs
1x – Left and right 6.35mm ¼ inch mono input

1x – 4mm binding post / speaker cable (red & black) outputs
1x – Left and right Speaker/Speakon outputs

Sleek and compact design
Durable metal body with breathable air vents on the front and a fan cooling system built in
UK power cable supplied (IEC)
Rack mountable – Takes up 2U on a 19” rack
Ground lift switch
Bridge mode switch – allows high power mono operation

Switchable clip limiter
Protected against - Short-circuit, overload, D.C. and thermal protection
Removable handles for a low profile installation.

Technical information:

Power Supply – 230V AC, 50Hz (IEC Connection)
Power output RMS per channel at 4 Ohms – 2x 300W
Power output RMS per channel at 8 Ohms – 2x 200W
Power output RMS bridge – 600W
Frequency response – 5Hz - 50kHz
Input impedance – 20K Ohms
Dimensions – 483mm x 266mm x 88mm (WxDxH)
Weight – 9KG

Further Information – How to install:

1) - Connect one of your source devices (CD player or mixer for example) to the amplifier via one of the inputs on the back of the amplifier.

2) - You can now connect the amplifier to your speakers by attaching a length of speaker cable to the positive and negative connections on the back of the amplifier. These positive and negative connections are often referred to as binding posts. Strip back the end of your speaker cable and slightly unscrew the binding post before inserting the stripped cable, now tighten back up to make a good contact. Alternatively, you can attach banana plugs to the end of the stripped speaker cable for a superior quality connection. If you have speakers that don’t have any binding post or spring terminal connections, you can always use one of the Speakon outputs. Always make sure the speakers you wish to connect are either the same wattage as the amplifier or higher to avoid blowing them at higher volumes.

3) - Finally, plug the IEC to UK mains power cable supplied into the power point on the back of the amplifier, take the other end of the cable and plug into a mains power socket. You can now simply select the input and this will play through the connected speakers.

We also stock the following products that you may need for a stereo set-up:

Speakers
Speaker Cable
Banana Plugs
Interconnect Cables (2 RCA cables, Speakon Cables and 6.35mm Cables)
Rack Mount Data Cabinets

Please search our shop or get in touch if you need any additional products.